Build Your Own Arcade Controls Forum

Main => Monitor/Video Forum => Topic started by: koolmoecraig on March 23, 2007, 05:59:10 pm

Title: Happs Vision Pro HELP NEEDED *****
Post by: koolmoecraig on March 23, 2007, 05:59:10 pm

Does anyone know how to adjust the horizontal position to the right further than the remote pcb lets you?

Anyone?  Is there a jumper or something?

Title: Re: Happs Vision Pro HELP NEEDED *****
Post by: draginit on March 24, 2007, 03:58:49 am

i had this problem for awhile, but just the opposite, i couldnt get it to fit in the screen(too wide),, what i found was a simple adjuster on the bottom board and carefully adjusted that by turning it the direction nessacary,,  i had a mirror on the other side to see what was going on with the screen.
-assuming its the vision pro 27",...in your manual, go to page 8..its in the bottom pic labeled sub H size(VR402)... really simple to do.

Title: Re: Happs Vision Pro HELP NEEDED *****
Post by: koolmoecraig on March 25, 2007, 02:19:50 am

This is on a 19" CGA one.

I don't see that adjustment anywhere.

dam it

Title: Re: Happs Vision Pro HELP NEEDED *****
Post by: koolmoecraig on March 26, 2007, 07:52:32 pm

Hey all.

I figured it out for anyone having the same problem.

There is a tiny tiny button on the chassis.  Its white with a black center. You push it in to pop it up and the image will shift about two inches.

PERFECT.