Build Your Own Arcade Controls Forum

Main => Monitor/Video Forum => Topic started by: skirge66 on April 08, 2003, 03:39:08 pm

Title: G-force 2 with D9200?
Post by: skirge66 on April 08, 2003, 03:39:08 pm

I have a 32mb G-force2 video board sitting around, I would like to use this card with my newly purchaced D9200 monitor. will this card do well with the monitor. I'm wanting to say it's an ATI but I'm not certain.

Title: Re:G-force 2 with D9200?
Post by: shmokes on April 08, 2003, 06:14:57 pm

It's an Nvidia not ATI.  I mean, it could be any of a number of manufacturers, but Nvidia makes GeForce graphic chipsets that compete with ATI's Radeon chipsets.  It should work fine with your monitor, though.

Title: Re:G-force 2 with D9200?
Post by: seaner on April 10, 2003, 01:15:25 am

FYI, I just tried my gf2 with my D9200.
It works, sure.. but when I wan the config tools, I couldn't get a LOT of modes to show up.. got the "OUT OF RANGE" message on the screen.
This happened mainly with the lower frequency modes, 15khz, 16khz, 25khz.  It would be possible to configure up the GF2 to work fine if you only want to run the vga frequencies..
this was using svgaline.. your mileage may vary of course.