Build Your Own Arcade Controls Forum

Main => Monitor/Video Forum => Topic started by: redfivexw on February 17, 2007, 09:48:42 pm

Title: minor problem with Donkey Kong Sanyo monitor
Post by: redfivexw on February 17, 2007, 09:48:42 pm

I have a Donkey kong Jr machine with the sanyo monitor.  The monitor gives a great picture, however the vertical hold has become touchy.  When i adjust the knob, it will hold fine.  When i turn the power on and off, the picture will move to the right about halfway so the picture is split in the middle.  I can adjust it back with the knob and it will hold in that location until i power it off again.  It always ends up in the same place, split in the middle.  Any idea where this problem is?  I dont want to pull the whole thing out and recap it just for this.  Is it the switch itself?  any advice would be appreciated.

Title: Re: minor problem with Donkey Kong Sanyo monitor
Post by: Ken Layton on February 18, 2007, 12:07:39 am

If it hasn't been recapped, then that's your problem.