Build Your Own Arcade Controls Forum

Main => Monitor/Video Forum => Topic started by: sfrascella on February 01, 2007, 01:31:13 pm

Title: Happ 19" Vision Pro
Post by: sfrascella on February 01, 2007, 01:31:13 pm

I just got a Happ 19" Vision Pro monitor for my Defender project, and the installation looks pretty straight forward but I wanted to run it by the group first before I do anything that could possibly damage it. It looks like I connect the red, green, blue, ground, v-sync, and h-sync to the corresponding pins on the board and then power it up.

Is this the case or am I missing something here? I know this is a total noob question, but this is the first time I have installed one of these.

Thank's for any help or advice.

Title: Re: Happ 19" Vision Pro
Post by: Rickn on February 01, 2007, 09:08:04 pm

Just Browsing, but before you plug it in- look for stickers or warnings... IS AN ISOLATION TRANSFORMER REQUIRED!!

If so make sure you use it or you will blow fuses, regulators...

Good Luck

Rick
Nieman Video Displays
Niemandisplays.com

Title: Re: Happ 19" Vision Pro
Post by: sfrascella on February 01, 2007, 09:29:57 pm

Thanks Rick, no isolation transformer is required with this one. I installed it tonight and it works perfectly. It actually was pretty easy, but since I had never done it before I was a little nervous.