Build Your Own Arcade Controls Forum

Main => Project Announcements => Topic started by: westell on August 31, 2006, 09:00:57 pm

Title: another robotron control panel fixer upper thingy :)
Post by: westell on August 31, 2006, 09:00:57 pm

Its been done over and over and it gets done over again :)

This one was wee bit harder but it turned out nicely. The tricky part was fixing the holes where the T nuts go which was done by adding some stiff wire in an offset x ways pattern to hold the bondo during a hardcore game. I gave it a good pull tug and jerk to make sure everything was good to go before putting on the cpo

If i can find some 4" red ball shafts i"ll be good to go :)

Title: Re: another robotron control panel fixer upper thingy :)
Post by: westell on August 31, 2006, 09:01:52 pm

more

Title: Re: another robotron control panel fixer upper thingy :)
Post by: Luigi on September 01, 2006, 08:43:13 am

Nice job :)


I have to fill one added hole, too.....but it's metal, not wood  :(

Title: Re: another robotron control panel fixer upper thingy :)
Post by: psychotech on September 01, 2006, 06:55:04 pm

!

That's great. Nice work, what else can I say :)