Build Your Own Arcade Controls Forum

Main => Consoles => Topic started by: mo1e on August 28, 2006, 08:41:56 am

Title: is it possible to turn a gamecube controller into a cp
Post by: mo1e on August 28, 2006, 08:41:56 am

hello all is it possible to rewire the gamecube controller buttons to my cp like you can with a dreamcast controller? i dont want to use the analogue stick just the dpad and buttons

Title: Re: is it possible to turn a gamecube controller into a cp
Post by: mo1e on August 28, 2006, 10:59:34 am

sorry to double post but heres a pic of the button connections which part of each button needs to have the silver revealed and have the wire soldered to it? if i remember on the dreamcast it was the left hand side theres a top bottom left and right to these

(http://img176.imageshack.us/img176/150/dscn0254pj9.jpg) (http://imageshack.us)

Title: Re: is it possible to turn a gamecube controller into a cp
Post by: TalkingOctopus on August 30, 2006, 01:10:35 am

I'm not sure.  However, I know hacking a ps1 controller and then using an adaptor will work.  But, if you'd like to try to hack the gc controller, I'll help identify some solder points when you post a better picture of the board.

Title: Re: is it possible to turn a gamecube controller into a cp
Post by: Otraotaku on August 30, 2006, 11:12:27 pm

it should be, but im not too sure about the analog... is it possible to hack the analog on a GC controller?