Build Your Own Arcade Controls Forum

Main => Woodworking => Topic started by: Dreamwriter on August 28, 2006, 01:21:58 am

Title: Plywood: if I'm applying vinyl to sides, do I need to stain/paint/clearcoat?
Post by: Dreamwriter on August 28, 2006, 01:21:58 am

Just what the subject says :)  I'm building my little arcade machine outta plywood, and planning on using that adhesive vinyl from Parts Express on all external surfaces.  So do I need to do anything to the wood?  You know, to make it last longer or something?  I'm an extreme woodworking newb :P

Title: Re: Plywood: if I'm applying vinyl to sides, do I need to stain/paint/clearcoat?
Post by: NightGod on August 28, 2006, 02:10:01 am

I throw a sloppy coat of paint on my CP before I applied the vinyl-I was worried about the wood absorbing too much of the adhesive and getting peeling issues later on down the line.

Title: Re: Plywood: if I'm applying vinyl to sides, do I need to stain/paint/clearcoat?
Post by: arcade-mad on August 29, 2006, 01:43:40 pm

I covered one of my cabs in fablon vinal and had no peeling problems as yet and its had a load of use and abuse  ;D

just apply the vinal then warm it up with the hairdrier to get the glue warm them smooth out any bubbles you get a great finish using this metod and better glue stickability (is that a word ?) when the vinal is warm.