Build Your Own Arcade Controls Forum

Main => Monitor/Video Forum => Topic started by: CPickler on August 16, 2006, 08:44:32 pm

Title: Arcade VGA to Wells Gardner
Post by: CPickler on August 16, 2006, 08:44:32 pm

I have a molex connector, the pins to go inside it, and the Arcade VGA breakout cable.  I am trying to connect them to my arcade monitor and have a question before I blow something out.  The monitor connection pins say they need H and V + pulse, whereas the Arcade VGA breakout cable only provides negative H and V pulse.  Is this going to be a problem, and anything else I am forgetting.

Thanks

Title: Re: Arcade VGA to Wells Gardner
Post by: SirPeale on August 16, 2006, 09:16:26 pm

You didn't indicate which WG monitor you have, but you should be able to put your sync pin on the end just fine.

Title: Re: Arcade VGA to Wells Gardner
Post by: CPickler on August 16, 2006, 09:53:03 pm

K7200 19"

So just connecting the negatives should be fine?

Title: Re: Arcade VGA to Wells Gardner
Post by: SirPeale on August 16, 2006, 10:33:19 pm

Yeah.  Just the end pin.