Build Your Own Arcade Controls Forum

Main => Artwork => Topic started by: JoshuaMiller on July 28, 2006, 03:00:02 pm

Title: Suggestions for printing service?
Post by: JoshuaMiller on July 28, 2006, 03:00:02 pm

I have not yet decided what finish to put on my CP.  I am mounting my sticks from the bottom, so ideally, I would like to have a graphic printed on vinyl or a similar material so that I do not lose any stick height by using plexi. 

Does anyone have any suggestions/ recommendations of where I can get something like this printed economically?  If it's too pricy, I'm just going to go with good paper uner thin plexi.

Also, does anyone have any insight into marterials?  What can I have this printed on where the ink would be permanent and waterproof, and not rub off after years of play?

Thanks for all your help, guys-

--Joshua--

Title: Re: Suggestions for printing service?
Post by: fatfingers on July 28, 2006, 03:12:08 pm

Check here (http://wiki.arcadecontrols.com/wiki/Vendors) for vendors (Under the Artwork section).

Title: Re: Suggestions for printing service?
Post by: JoshuaMiller on July 28, 2006, 05:58:20 pm

Thanks!

Title: Re: Suggestions for printing service?
Post by: Nannuu on July 31, 2006, 03:56:21 pm

I suggest Mame Marquees, they are excellent.