Build Your Own Arcade Controls Forum

Arcade Collecting => Miscellaneous Arcade Talk => Topic started by: USSEnterprise on July 23, 2006, 01:35:03 pm

Title: baby pacman oppurtunity, would need a PCB. Where can I get?
Post by: USSEnterprise on July 23, 2006, 01:35:03 pm

Have an oppurtunity for a close by Baby Pacman machine, missing one of the the three circuit boards. I believe the missing board is the video control board. Its the lowest board. Anyone have any idea where I can get a replacement board?

Title: Re: baby pacman oppurtunity, would need a PCB. Where can I get?
Post by: Kevin Mullins on July 23, 2006, 02:27:44 pm

I know I'd love to get ahold of a Baby Pac myself.

I don't know off hand who might have the video board.
But it is refered to as the VIDIOT board.

They were apparently problematic, and this is generally what is wrong with most of them.

Title: Re: baby pacman oppurtunity, would need a PCB. Where can I get?
Post by: USSEnterprise on July 23, 2006, 04:45:23 pm

Alright, cool, I found someone who has a few. Now does anyone know the dimensions of a Baby Pacman?

Title: Re: baby pacman oppurtunity, would need a PCB. Where can I get?
Post by: ChadTower on July 23, 2006, 08:29:01 pm

Roughly the same as a regular Pac man.  Not big.

Title: Re: baby pacman oppurtunity, would need a PCB. Where can I get?
Post by: RayB on July 24, 2006, 12:58:01 pm

They are much DEEPER than a regular pacman, no?

USS, look up the manual. They usually contain weight, and dimensions.

Title: Re: baby pacman oppurtunity, would need a PCB. Where can I get?
Post by: ChadTower on July 24, 2006, 04:15:15 pm

Could be but I don't seem to remember it being THAT much deeper.  The playfield is less than half the length of a real pin and the monitor is small.

Title: Re: baby pacman oppurtunity, would need a PCB. Where can I get?
Post by: pointdablame on July 25, 2006, 11:05:49 am

I would love to have a Baby Pacman, I've always liked them.

Title: Re: baby pacman oppurtunity, would need a PCB. Where can I get?
Post by: Kevin Mullins on July 25, 2006, 11:26:22 am

Has some dimensions towards the bottom of the page:
http://www.ggdb.com/GameByName.aspx?c=Coin-Op&s=Arcade&l=B&vid=213 (http://www.ggdb.com/GameByName.aspx?c=Coin-Op&s=Arcade&l=B&vid=213)

I think a good bit of the depth is just at the control panel compared to an average cab.
The pin playfield is tiny, but then again it has the CP directly in front of it also which makes it stick out some.

I still want one some day..... ;D

Title: Re: baby pacman oppurtunity, would need a PCB. Where can I get?
Post by: missioncontrol on July 27, 2006, 08:36:07 am

 :hissy: I know of a Baby Pac was ruined in a flood still brings a tear to my eye

Title: Re: baby pacman oppurtunity, would need a PCB. Where can I get?
Post by: Howard_Casto on August 01, 2006, 08:24:41 pm

Baby pacmans are apparently hard to maintain electroincs-wise.  I would suggest looking into the pinmame-hw project and mame it once you get it.