Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: fixedpigs on July 16, 2006, 09:07:52 pm

Title: best way to cut t-molding...?
Post by: fixedpigs on July 16, 2006, 09:07:52 pm

what is the best way to get a straight cut on the end of t-molding...?

                                                                                     thanks...!

Title: Re: best way to cut t-molding...?
Post by: Circo on July 16, 2006, 09:30:12 pm

I just used a utility knife, had no problems whatsoever.

Title: Re: best way to cut t-molding...?
Post by: javeryh on July 16, 2006, 10:21:13 pm

I used a utility knife too and it came out fine (not 100% perfect but close enough).  There is a thread around here somewhere where someone used a pipe cutter to get the perfect cut...

Title: Re: best way to cut t-molding...?
Post by: leapinlew on July 16, 2006, 10:55:22 pm

I used scissors.

Title: Re: best way to cut t-molding...?
Post by: somunny on July 17, 2006, 09:36:55 am

I have one of those cutters that places like Home Depot use to cut rubber/plastic tubing.  Perfect cut every time.

Steve

Title: Re: best way to cut t-molding...?
Post by: Ken Layton on July 17, 2006, 09:50:23 am

I used a cutoff wheel in a Dremel tool.

Title: Re: best way to cut t-molding...?
Post by: fixedpigs on July 17, 2006, 07:40:14 pm

thanks for all of the suggestions...!