Build Your Own Arcade Controls Forum
Main => Software Forum => Topic started by: mccoy178 on June 29, 2006, 12:34:00 pm
-
Okay. I have Z26 in my Atari2600 Roms folder. I have a .cli with the following command:
-v18
From the acrobat file, it says that -v1N should open Z26 in a window with N video mode. I can't get this command to work. Could someone please try this and let me know if and how they were able to get it to work. I am attempting to use this on a component t.v. and the only way it is playable and viewable is with this setting. I have had it running in X26, but I would like to get it going in Z26. :banghead: Thanks in advance for your help.
-
I'd say to double-check your config file and make sure the v is a lowercase v and not an uppercase V.
For me, when I used V (uppercase), it did nothing. Otherwise, v (lowercase) worked fine.
Granted, this was all on a PC monitor, but still...can't hurt to double-check.
Here is the command I ran at the prompt:
c:\emu\atari\z26> z26 -v18 combat
-
:banghead: Thank you very much. I just realized that I was dropping the roms onto z26 instead of using a command prompt when testing. I just went and tried it out and all is well. :banghead: