Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: Capthowdy on April 29, 2006, 04:49:11 am

Title: Do I have room for a 4-way?
Post by: Capthowdy on April 29, 2006, 04:49:11 am

...and please don't tell me to get a king size bed!   :P

Here's how i'm planning on laying it out.

Also...with the Happ Super joysticks that I have... Do I need to rout out the bottom so the stick will come up a little higher through the 3/4 mdf?  If so how far in should I go?  thanks

Title: Re: Do I have room for a 4-way?
Post by: Kremmit on April 29, 2006, 10:35:08 am

Depends on how big your CP will be.  Is that cardboard cut to size?  As it sits, I'd put one above the player 1 stick or buttons.  As for routing, stick height is a personal preference.  If you're not sure, I'd start out with no recess, and see how you like it.  You can always rout a recess later, but it's harder to un-route one, ya know?

Title: Re: Do I have room for a 4-way?
Post by: Capthowdy on April 29, 2006, 01:27:36 pm

oh jeez...sorry...the control panel will be roughly 23" wide by 15" deep.

I tested the joystick through a 3/4 inch piece and it felt a little low.  So I'm thinking I may rout it a bit but I don't want to make it weak.

Title: Re: Do I have room for a 4-way?
Post by: Kevin Mullins on April 29, 2006, 02:21:30 pm

Most joysticks have different (two) spacers to make them usable/adjustable for either 3/4 mdf or the thinner metal control panels. (height wise)
Two places on the shaft for the bottom clip.
I have never routed out for a joystick.

Is this true with the Happ Super Sticks?

Title: Re: Do I have room for a 4-way?
Post by: Kremmit on April 29, 2006, 10:36:10 pm

Nope, Supers are not height adjustable.  P360s and old Wico Pear-tops are the only ones I know of that are.