Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: Ninten-doh on January 22, 2006, 02:40:34 pm
-
Just curious how happy you were with the material they use.
-
This should have been posted in the "Artwork" section. Sorry!
-
They're top notch. You can't find any better.
-
I got a full set of artwork from mamemarquees last month. Before I could install it I found the kids had unrolled the cp overlay and rolled a deskchair + kid over it at least a few times.
I was much impressed to see there was not a mark on it!
-
Quarters, that's exactly the kinda feedback I was looking for! ;D
How hard/easy was it to apply the CP overlay? I'm planning to put it on a wood control panel.
-
I have a little tute in a thread i posted easlier about how I put on my overlay if your interested
link here
http://forum.arcadecontrols.com/index.php?topic=42111.0 (http://forum.arcadecontrols.com/index.php?topic=42111.0)
-
go with them. top notch quality, and SUPERIOR comms through the entire transaction, should you have any questions.
-
I used them and again... Top quality.
You should feel safe in your decision. Just make sure that your art is good. Because, what you send is what you'll get.
-
In the words of Tony the Tiger, they're great!
-
do they print what you send them? or do they vectorize and/or correct the work too?
-
only print and sometimes make sure that colors translate correctly. what you send is what you'll get. period.
-
do they print what you send them? or do they vectorize and/or correct the work too?
If you want someone to correct your work and you are paying for the service, it would be uuuuber expensive. Graphic work for pay is not cheap.
-
average rate: $50/hr
-
average rate: $50/hr
myup
-
Mamemarquees.com is a fantatic printing service! Going on three years with my marquee, CPO and side art and they are still in awesome condition with tons of play on it.