Build Your Own Arcade Controls Forum

Main => Monitor/Video Forum => Topic started by: CPickler on January 10, 2006, 04:47:49 pm

Title: K7200 Issues
Post by: CPickler on January 10, 2006, 04:47:49 pm

I just upgraded the standard 1988 Well's Gardner monitor that came with the Double Dragon 2 cabinet.  I put in a new K7200 and powered it up and the image is moving very quickly up and to the right.  I have adjusted all the controls I can see and they are not making much of a difference in the extreme rolling.  I used the same connector I wired up to use on the old monitor.  Do I need to rewire my connector for the new monitor?  I will attach pictures and more details in about an hour.

Title: Re: K7200 Issues
Post by: Thenasty on January 10, 2006, 10:34:48 pm

I have wg7202 monitor and I also had an old WG 46xx something. I don't remember exactly what happened when I connected the NEW one thinking it would just be a swap and it goes, I was wrong. I found out after lots of fidling that the NEW one's V-Sync/H-Sync must be separated. In my older setup, this wires was twisted to get composite connection and I'm assuming that this would be your case.

Title: Re: K7200 Issues
Post by: CPickler on January 15, 2006, 05:33:29 pm

thanks.

Where can I get the new molex (or plastic) connector for connecting to the monitor and connecting the wires into the connector?

Title: Re: K7200 Issues
Post by: Q*Bert_OP on January 16, 2006, 05:06:23 pm

Bob Roberts