Build Your Own Arcade Controls Forum

Main => Artwork => Topic started by: Pipercub on December 02, 2005, 07:35:36 am

Title: Applying full cabinet side art
Post by: Pipercub on December 02, 2005, 07:35:36 am

I have done about a dozen side arts so I have pleanty of practice in getting them centered and bubble free. But to date I have never applied a full side decal that covers the entire side of the machine and has to be trimmed to fit. In this case I am doing Centipede. Anyone have experience applying art that big?

Title: Re: Applying full cabinet side art
Post by: MikeQ on December 02, 2005, 10:15:50 am

Is this sideart that you had printed?  If so, where did you get it done and what were the dimensions.  I'm looking for someone that can print something 30"x54". 

As far as your question:  I plan on having the art printed slightly larger than the panel.  Apply the art on the panel with some overhang and then VERY carefully go back with a razor and trim off the overhang.