Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: koolmoecraig on October 14, 2005, 10:02:31 pm

Title: Can anyone make me a metal control panel??????
Post by: koolmoecraig on October 14, 2005, 10:02:31 pm

Hello,

I am looking for someone to make a metal control panel for me.

I need a blank(only the four corner carriage bolt holes are needed) Midway control panel from an original Pac-Man upright. The kind that had wood mounted to them. These are deeper than Ms. Pac-Man/Galaga control panels so those will not work.

The only ones that I can find online are the Ms. Pac/Galaga panels. Does anyone have a source for someone to make me one?

Thanks!

Title: Re: Can anyone make me a metal control panel??????
Post by: Mr. Bubblehead on October 15, 2005, 06:09:06 am

If you can give me dimensions I could make one for you.

Title: Re: Can anyone make me a metal control panel??????
Post by: jcoleman on October 15, 2005, 06:57:55 pm

I literally just finished installing a multicade control panel from www.arcadeshop.com on an old Galaxian (same cab as Pac Man) and it fits perfectly.  They're just $28, I'd give it a go if I were you.

John

Title: Re: Can anyone make me a metal control panel??????
Post by: koolmoecraig on October 15, 2005, 08:23:08 pm

Thanks for the info.

Could you do me a favor and measure the front face of the control panel from top to bottom(the front part without the overlay)?

I need to know how deep it is.

Thanks,
Craig