Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: Nataq on September 28, 2005, 11:57:12 am

Title: slot cutter bit for t-molding
Post by: Nataq on September 28, 2005, 11:57:12 am

Wich ones of these would be the good one for cutting the t-molding groove ?


http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_slot.html

the 3-wing 1/16 is what I need ?

Title: Re: slot cutter bit for t-molding
Post by: RetroACTIVE on September 28, 2005, 12:56:05 pm

Depends upon how wide your t-molding is...

1/16" is the correct cutter for 3/4" or smaller t-molding and 5/64" is the correct cutter for 13/16" or wider t-molding...

following www.tmolding.com recommendations.

Title: Re: slot cutter bit for t-molding
Post by: Nataq on September 28, 2005, 01:24:36 pm

I need 1/16. Im just wondering if this 1/16 bit on this page is really what I need :)

Title: Re: slot cutter bit for t-molding
Post by: RetroACTIVE on September 28, 2005, 01:30:55 pm

yup... just be sure to buy the whole thing if you don't already have a shank and bearing.

Title: Re: slot cutter bit for t-molding
Post by: Nataq on September 29, 2005, 11:31:58 am

thanks :)