The NEW Build Your Own Arcade Controls
Main => Artwork => Topic started by: Inman on September 16, 2005, 09:05:54 pm
-
I'm having some reusable mylar stencil sets made + overlay for the homebuilt Defender cabinet I am building. Problem is that I need the dimensions to send to the print shop. Is there anybody out there who could send them to me? At least the width + heighth? I'd much oblige.............. Thanks - email is: jinman@pnc.edu
-
Widest point -- 27.5 inches
Height from bottom to top of highest dot -- 49.5 inches
-
Thanks - appreciate the assistance!
Jason
-
No problem. But, I should clarify that on the height I was referring to the bottom of the image to the top of the dot, not the bottom of the machine.
-
Thanks for the specifics. Can't wait to get that side art on. The cabinet is looking a little bare without it...
-
How about dimensions of the Defender front art? Is there anyone out there who would be willing to send me the measurements? I'm assuming it's 24.5 inches wide, but I'm not sure about the height.... Thanks
-
I have it sitting right in front of me. I'll just have to get a ruler.
*leaves*
*returns*
The art is about 23.5 wide by 13.5 high. The front of defender is 24.5, so there is a .5" standoff of the art from the edges, and about a .5" standoff of the diamond art from the bottomand about a 1" standoff of the other bits from the bottom give or take. I've seen a lot of variation in them. I'm guessing they were eather done by hand, or with some really cheap automated paint application process, that would allow for a wide variance.
-
Cool - thanks for the info. Wanted to be sure before I gave the print shop the thumbs up. Take it easy.... 8)