Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: dabone on August 21, 2005, 08:56:31 pm
-
Picked up a couple of cabs this weekend.
Robotron conversion.
(Name the cab)
(http://home.comcast.net/~dabonetn/robotron.JPG)
And one I've been wanting a while.
(http://home.comcast.net/~dabonetn/defender.JPG)
Cost: 350.00
Robotron needed a ram and a sync board for the 4600.
(Had both laying around)
Defender was a pain in the #%#%&#*%&#(*%^#(*%^, ended up replacing the power harness, reflowing the linear power supply (It still provides -12 and 6.3ac)
Removed the TABLE CLOTH they had put under the glass.
I'm going to transfer the robotron boardset to my multiwilliams cab that I'm working on.
(http://home.comcast.net/~dabonetn/multiwilliams.JPG)
p.s. I'm putting a Super High Impact up for sale in the fs forum.
(I'm running out of room)
later,
dabone
-
Robotron conversion.
(Name the cab)
Tempest? Tough to tell from front, but that's my best guess.
-
Robotron conversion.
(Name the cab)
Tempest, I think. I'd have to see the profile.
Edit: as I was typing, someone else had the same idea.
-
Bingo, tempest it is.
Strange converting one classic into another.
Later,
dabone
-
Strange converting one classic into another.
Not if the monitor went out.
It was probably cheaper to do the conversion than to replace the monitor.