Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: mccoy178 on August 19, 2005, 03:10:01 am
-
Big news for me. I received my power on button from Ponyboy, and I really like the looks of it. The Block O is about an inch and a half deep, so hitting the button would take some work while playing. I have included some pics and have a question:
While the machine is off, how can I get that triangle to slowly flash, and when on, stay fully lit like now? I want to make it impossible to not at least wonder what that mysterious triangle does! I am using the smart strip, but I could use the usb power couldn't I? The pulsating is the bigger question. Thanks for the advice in advance.
(http://ohiostate.photosite.com/~photos/tn/614_348.ts1124433030000.jpg)
(http://ohiostate.photosite.com/~photos/tn/608_348.ts1124433144000.jpg)
(http://ohiostate.photosite.com/~photos/tn/616_348.ts1124434602987.jpg)
-
should I assume you have an ATX motherboard in there? if so its relatively simple
you take this circuit http://www.satcure-focus.com/tutor/page11.htm
this will give you a flashing LED, or find a simiular one of the appropriate speed you want. best if it runs off 3-5 volts. Now. ATX motherboards(connectors) have what is called 'standby power' where there is one pin that provides power even if the computer is off (for various reasons) This will be pin #9. the only purple cable on the molex connector.
-
Now that is a wonderful answer! ;D I will check into this over the weekend and post my results. Thank you very much for the work. We'll have to see how the soldering goes.
-
I'd like to add to the circuit. Pin 4 of the timer IC is a reset and
if you connect a 2N2222A transistor you can hold the timer IC in
reset when power is on. Connect emitter to gnd.
Connect pin 4 instead to the collector pin. Connect a 4.7K resistor
to the collector and +5 always on voltage. Connect a 10K resistor
to the base pin and the +5 voltage what goes to motherboard.
The LED will flash when motherboard is off and stay on when
powered up.
-
I'd like to add to the circuit.
-
In the example circuit changing the values of R2 and R1 will change
the on/off ratio and collectively the rate. You can play with
these values to get even on/off or quick on/ long off or what ever
you like.
A larger calue of C1 will slow the flashes and a smaller will quicken.
BTW: at 5V you will need a resistor in series with the LED start
with 1K or the LED will draw too much current and burn out.