The NEW Build Your Own Arcade Controls

Main => Main Forum => Topic started by: ninjazx7 on December 16, 2002, 04:20:50 pm

Title: Do touching wires matter? (JAMMA)
Post by: ninjazx7 on December 16, 2002, 04:20:50 pm

Hi guys, I was wondering if touching wires matter in a JAMMA cabinet. I am going to try any power everything up tonight, and I know that there are some wires that I won't connect just to test all of my stuff. Does it matter if these wires are touching? Will it short something out or damage the PCB?

Thanks,
Matt

Title: Re:Do touching wires matter? (JAMMA)
Post by: rampy on December 16, 2002, 04:30:14 pm

Quote from: ninjazx7 on December 16, 2002, 04:20:50 pm

Hi guys, I was wondering if touching wires matter in a JAMMA cabinet. I am going to try any power everything up tonight, and I know that there are some wires that I won't connect just to test all of my stuff. Does it matter if these wires are touching? Will it short something out or damage the PCB?

Thanks,
Matt

are you asking if loose wires (not connected to anything) that have copper showing is a moderate risk for a short that could toast your PCB? Well yeah...  possibly.  You could  temporarily shlop some electrical tape over the exposed ends just in case, before you power it up and bend the wires away from eachother/other bad places to touch...

Just cause you have loose wires doesn't automatically mean you'll toast your game/monitor/etc... but you're increasing your risk of accidently do something stupid/costly with a bump here or there while you're reaching in there or whatever...

good luck...
rampy

PS wire nuts also work nice but are probably overkill for a test run...

Title: Re:Do touching wires matter? (JAMMA)
Post by: ninjazx7 on December 16, 2002, 04:36:55 pm

 ::) Duh....electrical tape.....God, it's been a long day at work. I didn't even think about doing that. Thanks alot.
Matt