Build Your Own Arcade Controls Forum

Arcade Collecting => Miscellaneous Arcade Talk => Topic started by: seinologist on June 26, 2005, 05:06:55 pm

Title: Tron Upright
Post by: seinologist on June 26, 2005, 05:06:55 pm

Hello everybody!

I've been a member for a while but this is my first post. I do have to say this site is awesome! When I found it I immediately
ran out and got the Project Arcade book. Actually I just clicked my mouse a few times on Amazon ;D

Ok, I have a Tron Upright that had been converted to a 1942 some time in it's life. After grabbing pieces here and there
mostly from ebay I'm ready to do a test run of everything. I have it all set up on my test bench and not in the cabinet. The cabinet
is gutted for preperations on it next week while I'm on vacation.

I don't have the harness that connects the monitor to the cpu board. Coming from the monitor are 5 wires. R,G,B, & Black and White.
Does anyone know if there are other wires hooked up besides these?

unplugged

Title: Re: Tron Upright
Post by: Q*Bert_OP on June 26, 2005, 05:10:43 pm

Yes, the power wires, and theblack wire is video ground, and the white wire is video sync.

Title: Re: Tron Upright
Post by: seinologist on June 26, 2005, 05:28:32 pm

Thanks. I have the power wires hooked up already.

The tron manual shows a "Yel + Strand" wire which isn't present on my monitor and I wasn't sure if it
was something that was eliminated during the conversion. It also shows a "V10 + Tan" which isn't present either.