Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: Reg on December 01, 2002, 06:41:02 pm

Title: How to install HappControls Bezel and Plexi?
Post by: Reg on December 01, 2002, 06:41:02 pm

 ???

Hi,

How do you install the HappControl bezel and Plexi on a
Cabinet that was based on Lusid blueprint?

I will like to make a genuine Look as possible...

thanks
Reg

Title: Re:How to install HappControls Bezel and Plexi?
Post by: Lindner24 on December 02, 2002, 11:14:46 pm

This is how I set up one of my projects...

I used Aluminum "U" channel and some foam weather stripping. (The peel and stick stuff)

-Drill some mounting holes in the U channel.
-Paint or tape the top of the U channel black.
  (Black Electrical tape is the easiest and it actually looks really good)
-Stick the insulation on both sides, inside the U channel.
-Screw into place with some flat screws

Get the foam a little less narrow than the U channel,
 so it doesn't stick out when compressed.
Also, Be careful cutting your plexi and bezel,
 leave clearance for the screws.