Build Your Own Arcade Controls Forum
Main => Buy/Sell/Trade - non-retail => Topic started by: AlanS17 on May 05, 2005, 12:44:53 pm
-
I'm looking to restore a Taito Jungle Hunt. I have a cab in decent condition, but I still need a marquee, bezel, CP, and PCB.
I'm most interested in the PCB, though. I can find the artwork elsewhere. It seems easier to find than the board, itself. Any leads???
-
You just missed a working Jungle King on ebay. Ended last night and looked clean.
-
Well Jungle Hunt and Jungle King are very similar, but I want Jungle Hunt. I suppose either would be fine, but only if I could find all the corresponding artwork for it. I'm looking to fill a green Taito cab.
-
The Jungle King bezel is tough to find. There are a couple in PA that are available, but that's all I know of and I don't know what condition they are in. Unless you went repro. Then you can get both the JK marquee ($30) and bezel ($40), but no control panel overlay that I know of unless you went with the sunset red.
The Jungle Hunt art is all available repro AFAIK.
It *should* be a simple ROM swap from one to the other. Let me know if you go that route. I've been curious for some time now.
I've seen a couple control panels lately, they were pretty rough though.
-
Jungle King has cooler audio, you might want to run "King" roms even if you use "Hunt" artwork.
-
Apparently all the artwork I had located yesterday is already sold today... >:(
Back to the drawing board. I'll run either game, but I wan it to be uniform. Either ALL Jungle Hunt or ALL Jungle King.
-
*whistles* BUMP! *whistles* :angel: