Build Your Own Arcade Controls Forum
Main => Software Forum => Topic started by: daveg2000 on May 01, 2005, 02:42:51 pm
-
I'm going through and assigning all of my buttons on my panel
today.
running into an issue.
In the WinIPAC program, (in the 'chart' mode)
I've programmed PLY3, BUTTON 5 to act as the 'P' key.
Yet, when I press the button and test it while
WinIPAC is still running, I cannot
get that box to highlight....
If I go into notepad, it flashes the message on the screen:
'
-
Forget it.
After 2 hours of beatin my head against a wall, reprogramming,
rewiring some things, I kept coming up with the same thing...
Then I thought... what If I shut down the PC and unplug the IPAC..
IT WORKED.. all my settings were 'permenant' after the PC
came back up...
that was weird.....