Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: Zeosstud on April 27, 2005, 04:58:05 pm

Title: Help!! Happ 27" Monitor Bezel
Post by: Zeosstud on April 27, 2005, 04:58:05 pm

Was hoping someone might have a Happ 27" Plastic Monitor Bezel laying around and could tell me what the height and width are.  Trying to figure out if its gonna work in my cab which is 27.5 inches wide.  I believe that is pretty standard so I figure I am okay, just wanting to check.

Thanks,

Zeosstud

Title: Re: Help!! Happ 27" Monitor Bezel
Post by: Teknique on April 27, 2005, 05:04:35 pm

happend to be in front of it now-

29 1/2" wide  by 25 1/2" height is my current one using a UAII cab design.  I trimmed it down a bit but that should give you minimums Im guessing.

Tek

Title: Re: Help!! Happ 27" Monitor Bezel
Post by: Zeosstud on April 27, 2005, 06:02:19 pm

You rock, thanks.  Plenty big enough.  You can always take some off, putting it back on however, thats the hard part!

Rodney

Title: Re: Help!! Happ 27" Monitor Bezel
Post by: paigeoliver on April 28, 2005, 05:55:30 am

They come square and massive. I have an uncut one at home, but I also had to cut one for my giant cab. It is a giant  cabinet and I still had to trim off massive amounts of bezel.

Title: Re: Help!! Happ 27" Monitor Bezel
Post by: elvis on April 28, 2005, 06:48:01 am

Quote from: paigeoliver on April 28, 2005, 05:55:30 am

They come square and massive. I have an uncut one at home, but I also had to cut one for my giant cab. It is a giant  cabinet and I still had to trim off massive amounts of bezel.

It's better needing to cut bits off than it is having to try and add bits back on! :)