Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: kenzo42 on April 12, 2005, 02:21:52 am

Title: can somone check my wiring? (pic)
Post by: kenzo42 on April 12, 2005, 02:21:52 am: http://pg.photos.yahoo.com/ph/liu_feng_yi/detail?.dir=/3917&.dnm=1d8c.jpg&.src=ph

http://pg.photos.yahoo.com/ph/liu_feng_yi/detail?.dir=/7922&.dnm=2c8b.jpg&.src=ph

so this is my wiring for my dreamcast to arcade monitor:

--5v wire connected to 1ohm 25 watt resistor connected to ground. i guess it looks like this... 5v-----{resistor}-----ground. it's in the pic at the right side.

can resistors be installed backwards?

--12, N, 13 from jamma finger connected to RGB from DC vga monitor cable pins #1,2,3
--P (sync) from JF connected to hor and vert sync (twisted together) from monitor cable 13 & 14
--14 (ground) from JF connected to ground from monitor cable pin #10

how does a picture look on a computer monitor when it is running at 15khz, if it actually displays something?

thanks.
Title: Re: can somone check my wiring? (pic)
Post by: Craig on April 12, 2005, 03:08:48 am: Quote from: kenzo42 on April 12, 2005, 02:21:52 am

can resistors be installed backwards?

Resistors can be placed either way.

I have to squint to see the pictures. :o :o
Title: Re: can somone check my wiring? (pic)
Post by: cholin on April 12, 2005, 10:28:41 pm: Where did you get those boards, did you actually buy them from the site listed on them? Im looking for some cheap boards and I heard they are like 2 bucks at most.
Title: Re: can somone check my wiring? (pic)
Post by: kenzo42 on April 13, 2005, 12:25:14 am: www.jammaboards.com