Build Your Own Arcade Controls Forum
Main => Monitor/Video Forum => Topic started by: RetroJames on February 13, 2005, 11:20:15 pm
-
I parted out a Galaxian today.
-
The "Black Level Control" (a.k.a. Brightness) is set a tad bit too high and needs to be turned down a little. This is a common thing on the 4600 series monitors.
-
Also I'm thinking if its just the red letters getting blurred your red saturation may be too high. of course I can almost guarantee that a cap kit has never been done so your colors are all likely off.
-
Turn down the black level first. Chances are too that if the monitor has not had a capkit done that the black level pot could be bad (a common failure item). A new one is included in the capkits from Zanen Electronics.