Build Your Own Arcade Controls Forum

Main => Monitor/Video Forum => Topic started by: wakerlet on February 04, 2005, 11:43:09 am

Title: Wanted: Your 13" Impedance Readings
Post by: wakerlet on February 04, 2005, 11:43:09 am

I know there was another thread out there regarding this but it looks like it contained mostly 19" monitors.  I'm looking for a good chassis to use for a few low impedance tubs I've pulled out of TVs and my chassis is currently high impedance.  I'll post my values later today. 


Thanks!
-Todd

Title: Re: Wanted: Your 13" Impedance Readings
Post by: Ken Layton on February 04, 2005, 11:50:14 am

A lot of 13" tubes have the 8 pin (22.5 mm diameter) neck.

Title: Re: Wanted: Your 13" Impedance Readings
Post by: wakerlet on February 04, 2005, 06:59:43 pm

Yeah, of the four old TVs two were 8 pin and two were 10 pin, all low impedance.  Both my 13" Electrohome and WG are high impedance and 10 pin necks.