Build Your Own Arcade Controls Forum

Main => Software Forum => Topic started by: vincentc77 on January 28, 2005, 10:03:26 am

Title: advmame, dos, and tbalde64 install
Post by: vincentc77 on January 28, 2005, 10:03:26 am

I'm finally getting all of the pieces and knowledge together inorder to try getting my 25kHz monitor to properly display the advcfg setup screen.  I'm going to try these steps tonight:

- set pclock at 5-90
- set hoz freg at 24.9 KHz
-set vetical freq at 47-63 Hz.
- play with shift 'i'
-increase/decrease horz freq by .01
-repeat until screen is viewable.

-Does anyone know if any special lines in the rc file  are needed for the tblade 64, or any TSRs?  Remeber this is for DOS using a WG U3000 EGA arcade monitor.   Anyone want to add anything?

Thanks,
Charlie

Title: Re: advmame, dos, and tbalde64 install
Post by: whammoed on January 28, 2005, 10:21:00 am

Yes,
I thought the U3000 was a 31Khz monitor?
http://www.happcontrols.com/monitors/49083200.htm
 ???

Title: Re: advmame, dos, and tbalde64 install
Post by: vincentc77 on January 28, 2005, 11:23:41 am

The model number is 33K3201, according to WG.  It was in an NFL Blitz cab which is an EGA game.

Charlie

Title: Re: advmame, dos, and tbalde64 install
Post by: Thenasty on January 28, 2005, 11:55:06 am

Quote from: vincentc77 on January 28, 2005, 11:23:41 am

The model number is 33K3201, according to WG.

Title: Re: advmame, dos, and tbalde64 install
Post by: whammoed on January 28, 2005, 12:03:45 pm

I imagine it may be possible to adjust the horizontal frequency on that monitor to get it to sync with 25hz instead of 31hz.  I had a U3100 that you could adjust quite a bit/

Title: Re: advmame, dos, and tbalde64 install
Post by: rockmes on January 30, 2005, 07:20:18 pm

you will find what you need on this site- the tsr and the setting you need
http://easymamecab.mameworld.net/