Build Your Own Arcade Controls Forum

Main => Software Forum => Topic started by: Florp on December 20, 2004, 05:48:11 pm

Title: Mamewah Daphne double-run?
Post by: Florp on December 20, 2004, 05:48:11 pm

Hi guys! I've got Mamewah hooked up to launch Daphne games using the .bat file method, and it mostly works except for one problem: Mamewah runs Daphne games twice. I select the game, hit the start button,  the game loads. I exit the game, and Mamewah immediately pops back up its "Loading..." screen, and the game runs again.

Mame games under Mamewah don't do this.

Any suggestions?  ???

Thanks,

-Scott

Title: Re: Mamewah Daphne double-run?
Post by: Minwah on December 20, 2004, 07:25:44 pm

Make sure you have show_dos_box no in your emuname.ini file

(If that fails set it to yes)

Title: Re: Mamewah Daphne double-run?
Post by: Florp on December 20, 2004, 08:09:45 pm

That did it! Show DOS Box set to No or Yes fixed the problem; it's just Auto that double-ran.

Thanks, Minwah! And thanks for Mamewah, it's a really nice front-end.

-Scott

Title: Re: Mamewah Daphne double-run?
Post by: Minwah on December 21, 2004, 05:37:16 am

Quote from: Florp on December 20, 2004, 08:09:45 pm

That did it! Show DOS Box set to No or Yes fixed the problem; it's just Auto that double-ran.

Thanks, Minwah! And thanks for Mamewah, it's a really nice front-end.

Thanks :)

FYI the reason it 'double-runs' when set to auto is that it is attempting to do a 'daphne -verifyroms' - Daphne doesn't have this switch so the switch is ignored.  Basically 'Auto' only works for MAME.