Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: gique on December 08, 2004, 05:11:17 am

Title: 6 button setup question
Post by: gique on December 08, 2004, 05:11:17 am

what is needed to get a 6 button setup working on a cab using a J-pac?

thanks!

Title: Re: 6 button setup question
Post by: paigeoliver on December 08, 2004, 05:21:33 am

The Jpac, the buttons, a jamma harness, and some extra wires for buttons 4-6, since those buttons are not on the jamma harness.

Title: Re: 6 button setup question
Post by: gique on December 08, 2004, 06:08:13 pm

any idea where these extra wires go?

Title: Re: 6 button setup question
Post by: paigeoliver on December 09, 2004, 03:36:36 am

Do you actually HAVE your JPAC yet?

If not, wait until you get it, it is labeled.

Title: Re: 6 button setup question
Post by: gique on December 09, 2004, 01:57:29 pm

yes, I do have my Jpac

- I was wondering where the button wiring went on the jamma connector.

Title: Re: 6 button setup question
Post by: disaac on December 09, 2004, 02:21:39 pm

Since I am a 2 day old 1st Jamma cab owner, please take my guess with a grain of salt.

From what I have been reading, the buttons 1-4 should be already wired up to the Jamma Harness.  This funcitonality will be carried through the JPAC to the PS2/USB already.

Since the Jamma harness can only supports the 4 buttons, the extra 2 buttons have to be wired directly to the JPAC to be sent to the PC.

I think this post was more for my knowledge than anybody elses :D.  Can someone confirm this for Gique and I?