Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: vader on December 02, 2004, 10:47:51 pm

Title: Happ GT TB AND BOB ROberts
Post by: vader on December 02, 2004, 10:47:51 pm

Does anyone know if the Happ Golden Tee TB that Peale is selling and the Happ 3" mounting plate that Bob Roberts is selling are the same ?  Got the ball coming just want to make sure on the plate

Tim

Title: Re: Happ GT TB AND BOB ROberts
Post by: GGKoul on December 03, 2004, 12:49:15 am

If its a 3" track ball, then they should use the same mounting plate.

Title: Re: Happ GT TB AND BOB ROberts
Post by: paigeoliver on December 03, 2004, 02:10:05 am

I have 3 different mounting plates for 3" trackballs, and I have two different models of 3" trackball, imperial and Golden tee (Happs), and all of them work with each other.

Title: Re: Happ GT TB AND BOB ROberts
Post by: vader on December 03, 2004, 06:17:37 am

Thanks guys.......they all looked the same but I just wanted to be sure

Thanks Again

Tim

Title: Re: Happ GT TB AND BOB ROberts
Post by: u_rebelscum on December 03, 2004, 02:57:38 pm

Quote from: GGKoul on December 03, 2004, 12:49:15 am

If its a 3" track ball, then they should use the same mounting plate.

There's one exception:  the happs high ball.  It needs a bigger plate because the ball is sitting higher.

Oh I guess there is another exception.  Since happs are inches while the betson metric, some people have had problems with a happs TB and a betson mounting plate.  Aparently betson's hole is a little smaller than happs TB.  OTOH, Betson TBs are fine on happs plates.