Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: ekans on November 27, 2004, 09:52:15 pm
-
>:(
OK, I feel like a bit of an idiot. I can't seem to get the E-Stick apart to mount it through my control panel.
There is obviously a threaded top that goes into the base, but there is something that is stopping it from unthreading. I'm afraid to put too much force on it and break it.
What gives. Am I just not holding my tongue right?
-
OK come on, everyone stop laughing at me and reveal to me the obvious way to do this. I am putting the last coat on today and have test fitted everything else.
The Ultimarc site has a nice exploded view of the T-Stick but not the E-Stick so no luck there.
You can even include stupid Canadian jokes in your replies... ::)
-
Installation
This is obviously the E-Stik's main claim to fame, and it is a cinch to install, especially with the easy twist-off bottom (I'm going to be mentioning "twisting" a lot in this review, so just get used to it ;-) The bottom part of the joystick, which houses the microswitches, simply pops off with a 90