Build Your Own Arcade Controls Forum

Main => Consoles => Topic started by: arcadecab on November 25, 2004, 05:48:49 pm

Title: Time Crisis 2 and 3 calibration question
Post by: arcadecab on November 25, 2004, 05:48:49 pm

I just purchased the ebay package of Time Crisis 2 and 3 and 2 guncon2 guns.  I tried it on my 32inch Panasonic television and I am unable to calibrate the guncon with either game.  The gun shoots about 1-2 inches to the right of where I am aiming at all times.  Not sure how to change it.  Does anyone have any ideas?  Is it my television or do I have to adjust anything on my tv.  I tried it on a little 13" television and it worked perfectly.  Not sure why it wont seem to work on my main television.  Any suggestions would be greatly appreciated.
Thanks.

Title: Re: Time Crisis 2 and 3 calibration question
Post by: Dave_K. on November 25, 2004, 07:16:51 pm

Is yout 32" tv an hdtv or rear projection?  Is it a 100hz refresh tv?

Title: Re: Time Crisis 2 and 3 calibration question
Post by: arcadecab on November 25, 2004, 07:22:59 pm

It is not a HDTV or Rear Projection TV.  Not sure about the 100hz refresh rate--it is about 5 years old and a good quality Panasonic Superflat television.  Nothing special and/or incredibly new.  It registers the shots, just that they are off by about an inch or so and have no way that I can tell to correct it.
Thanks.

Title: Re: Time Crisis 2 and 3 calibration question
Post by: Dave_K. on November 26, 2004, 02:58:11 am

Try turning your contrast and brightness to 100%, then calibrate the guns.