Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: Granger on November 24, 2004, 12:56:56 am

Title: a little sag on the right!
Post by: Granger on November 24, 2004, 12:56:56 am

building an ultimatearcade II cab, was coming along very well... bolted right side down, stood upright, leveled and clamped left side, but slid 1/2 inch while drilling. ouch!!!! What do  I do?

Title: Re: a little sag on the right!
Post by: krick on November 24, 2004, 01:15:17 am

Not really sure what advice to give you other than the generic answer that everyone will probably give you...

Drill it again in the correct spot and fill in the extra hole with some wood filler.

Title: Re: a little sag on the right!
Post by: Granger on November 24, 2004, 01:27:31 am

1/2 inch bolts, 1/2 inch off,  basically i will have to make a slot. worried it will not stay and slowly drift down over time.

Title: Re: a little sag on the right!
Post by: Kremmit on November 24, 2004, 01:56:46 am

Get a 1/2" dowell and use it to plug the wrong hole, then drill your new one.

Title: Re: a little sag on the right!
Post by: Granger on November 24, 2004, 02:08:26 am

should have thought of that. was too upset to think of the obvious answer. thanks!