Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: IguanaStorm on September 25, 2004, 03:32:46 pm
-
i got all the buttons to work but when i hook any direction up to the 360 stick it acts like its grounding out. for example when i load up a game and if i only have left hook up to the 360 stick, than the game acts like im holding left. there is no solder touching the ground side of the D pad contact. any ideas???
-
one more thing... im sure its the 360 stick because when i un hook the 360 stick and just leave the pad plugged in it does not hold left. i know the stick worx because i used it with a different pcb.
-
not that i know alot about this topic but i'm having problems also
check your +v connection.. without +5 hooked up, the joystick connection always looks like it's on
my +5 psx hack wire didn't work so i hooked it up to another source and it worked
-
what type of power source did you use????
-
what type of power source did you use????
i have an ipac i'm going to use
(for admin buttons and dedicated 4 way)
over kill but hey..what can i say
-
the ipac has a power source?
-
http://www.ultimarc.com/ipac2.html
looks toward the bottom ....
there should be 9 pins (1 missing for ground)
right above where you plug in wires
i stole it from there
if you have an ipac ve, +5 has it's own connection at end