Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: rchadd on August 27, 2004, 06:03:47 pm

Title: ILMech BYOAC token adjustment
Post by: rchadd on August 27, 2004, 06:03:47 pm

help!

i've just tried to adjust my ILMech to take the BYOAC tokens as shown at http://www.miavio.com/HappILMech.htm

but i've taken slightly too much off! it now rejects every token  :'(

any suggestions on best way get it working?

i'm wondering if i can glue the L swing arm in place? but not sure if that would work

alternatively is it possible to adjust the ILmech to accept all coins?

Title: Re:ILMech BYOAC token adjustment
Post by: rchadd on August 27, 2004, 06:27:44 pm

i've just noticed that if i tilt the mech back slightly the coins are accepted.

i am wondering if there is another adjustment i can make?

Title: Re:ILMech BYOAC token adjustment
Post by: rchadd on August 27, 2004, 07:27:43 pm

i think i have fixed it ;)

i figured out that the tokens were being rejected at the magnet check. as i am not worried about this check i simply applied some tape over the reject slot to force the coin into the accept slot. its accepting all tokens now!