Build Your Own Arcade Controls Forum

Main => Software Forum => Topic started by: Evilpenguin on July 27, 2004, 05:20:26 pm

Title: Mamewah and Zsnesw
Post by: Evilpenguin on July 27, 2004, 05:20:26 pm

How do you get mamewah to just load the rom.  When I click on a rom it just brings up the interface of Zsnes?  Any ideas?

Jason

Title: Re:Mamewah and Zsnesw
Post by: TalkingOctopus on July 27, 2004, 05:43:24 pm

Makes sure you are using the following settings in the MAMEWAH emu#.cfg for zSnes:

Show DOSBox = 1
Send ROM Path = true
Use Long Filenames = false
Send ROM Extension = true

Title: Re:Mamewah and Zsnesw
Post by: Evilpenguin on July 27, 2004, 06:36:14 pm

Thats exactly what I have.  The roms show up in mamewah and when I click on one of them to load it just brings up the gui for ZSNES, any ideas, I suppose I could use the controls to select load and then select a rom, but I should not have to I would think.

Jason

Title: Re:Mamewah and Zsnesw
Post by: TalkingOctopus on July 27, 2004, 07:29:22 pm

Try the version of zSnes that you can download from the screenshot archive:  http://www.screenshotarchive.com/downloads_emus.htm (http://www.screenshotarchive.com/downloads_emus.htm)

Title: Re:Mamewah and Zsnesw
Post by: Minwah on July 27, 2004, 08:02:16 pm

Try using Long Filenames...

It has been a while since I had ZSNES setup so I can't remember fully, but I know for sure it works.  The GUI appearing is basically telling you something is wrong with the rom part of the commandline.

If all else fails run ZSNES from a commandline until you figure out how to run it, then try to duplicate that in MW (use debug.log to help).