Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: crashwg on June 25, 2004, 01:19:08 pm
-
I say ?22guage? becuase I'm not quite sure what I have, but I know it's pretty close to that...
Anyway, due to the recent discovery of the fact that the minipac that I ordered does infact suport a TB, I have decided to keep it insted of selling it just to buy the one with TB support.
So, I need to make my own wiring harness as I was too cheap to buy it with my original purchase.
Where can I get a 40pin IDE header capable of accepting a 22 guage wire? Also there is a 10 pin set of pins on the board... should I just get two 40pin headers and cut one down to 10?
And 1 more thing, where can I find the "pull up resistors" that are required by the minipac to use an ultimarc trackball how many do I need and where do I put them?