Build Your Own Arcade Controls Forum

Main => Monitor/Video Forum => Topic started by: wfg97079 on June 07, 2004, 08:54:45 pm

Title: Connection on monitor end
Post by: wfg97079 on June 07, 2004, 08:54:45 pm

I have a refirb wells gardner monitor, this is the type of connector that is on the monitor, where can I get a connector to fit it?

Title: Re:Connection on monitor end
Post by: Ken Layton on June 07, 2004, 11:33:19 pm

Mouser Electronics (www.mouser.com) part number 538-09-50-7101 (56 cents) or # 538-09-50-3101 (56 cents) for the plastic connector housing. You'll also need 6 of # 538-08-50-0106 pins (8 cents each) and crimper tool # 538-63811-2200 ($170).

You could also order the cable with connector assembly ready-to-go from Bob Roberts for around $10.

Title: Re:Connection on monitor end
Post by: SirPeale on June 08, 2004, 11:37:43 am

You don't need *that* crimper, do you Ken?  I mean, I've seen molex crimpers go for like $20 or less.  The one that you recommended to me earlier, for example.

Title: Re:Connection on monitor end
Post by: Ken Layton on June 08, 2004, 07:17:01 pm

No, you don't absolutely have to have the crimper quoted in the above post. It was the only one listed in the Mouser catalog I have. There is a cheaper hand crimper that Molex/GC/Waldom makes but I don't have the number handy.

Title: Re:Connection on monitor end
Post by: SirPeale on June 09, 2004, 07:23:52 am

It's Molex part #W-HT-1919.  Luckily I saved the email you sent me before.  Available @ http://www.mcminone.com

Title: Re:Connection on monitor end
Post by: fredster on June 09, 2004, 11:50:56 am

Did you read the Monitor FAQ?

Bob Roberts Sells them, but you better be ready to buy more to cover shipping.