Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: crashwg on May 06, 2004, 11:00:21 pm

Title: .94" drillbit?
Post by: crashwg on May 06, 2004, 11:00:21 pm

I just got some "Blue Momentary Contact Pushbuttons" from happ, http://www.happcontrols.com/pushbuttons/601200xx.htm (http://www.happcontrols.com/pushbuttons/601200xx.htm), and I've noticed that the mounting hole they require is .94"...  I've never heard of a .94" drill bit, has anyone else?  I know that's pretty close to 1", but the lip of the bezel is only .06" larger leaving only .03" on each side!

Title: Re:.94" drillbit?
Post by: OSCAR on May 06, 2004, 11:21:08 pm

A 15/16" (.9375") should work just fine.  Or if you have access to metric drill bits, you can use a 24mm (.945").