Build Your Own Arcade Controls Forum

Main => Artwork => Topic started by: SuperRabbit0 on May 01, 2004, 01:38:59 pm

Title: Printing Small CPO & Marquee
Post by: SuperRabbit0 on May 01, 2004, 01:38:59 pm

I am building a small tabletop machine and my CPO and marquee are small enough to fit on legal size paper.

Does this open the door to any cheaper printing options?

Before I swallow shipping to Canada for such a small print job I thought I would give Kinko's a whirl.  It would allow me to get this project complete quickly too     :)

If I try Kinko's, what should I get them to print it on?

Title: Re:Printing Small CPO & Marquee
Post by: paigeoliver on May 01, 2004, 11:45:11 pm

I did my Defender marquee on vinyl at Kinkos and it came out pretty good. Not as good as a silk screened item, but more than passable.

If you are using plexi on the marquee and control panel (and aren't backlighting either), then you can probably just use cardstock.