Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: Piss Ant on April 23, 2004, 02:13:33 pm

Title: Installing an Over/Under Coin Door. Help please.
Post by: Piss Ant on April 23, 2004, 02:13:33 pm

Hello all,
I seem to remember reading a couple of months back or so about installing a Happs Over/Under Coin door that someone posted a link or perhaps a pic on printing out a templete so one would know how large to cut the hole for the door.  I've searched for a while now & can't seem to find the thread. :'(  Can anyone help me out.  I'd like to install mine now, but not sure how to get the hole just the right size - That thread was - & now you guy's are my only hope.

"Help me BYOAC, you're my only hope" sorry but after typing the previous sentence I coundn't help but change it to reflect a famous movie line. ;)

Thanks,
Piss Ant

Title: Re:Installing an Over/Under Coin Door. Help please.
Post by: Santoro on April 23, 2004, 02:17:17 pm

Fromm the Happ website:

(http://www.happcontrols.com/images/40/40003800_new_mounting.gif)

Title: Re:Installing an Over/Under Coin Door. Help please.
Post by: Minwah on April 23, 2004, 04:30:17 pm

I just turned mine over and traced it.  Then draw a line 1cm or so within that line and cut that out.  Then I had to jigsaw a few notches out to allow for the 'bumps' on the coin door :)

Title: Re:Installing an Over/Under Coin Door. Help please.
Post by: Piss Ant on April 23, 2004, 05:24:01 pm

Excellent, That should do it.
Thanks Guys!