Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: Shredder on April 15, 2004, 06:40:26 pm

Title: Coind Door Wiring, Question...
Post by: Shredder on April 15, 2004, 06:40:26 pm

What wires do you need to startup free play?  One wire is a ground, and the other is a 'coin1' wire from the Jamma harness, correct?

I re-wired it to my free play start button, so I don't have to insert a quarter each time, and for some reason, nothing happens when I press it.  Could it be that the wire has to be setup a certain way in the Barrel Insulated Female Connectors?

Title: Re:Coind Door Wiring, Question...
Post by: SirPeale on April 15, 2004, 06:41:57 pm

Did you wire it to both the coin door AND this button?

Just the button alone?

Title: Re:Coind Door Wiring, Question...
Post by: Shredder on April 15, 2004, 06:48:26 pm

Nope, just the button alone.  And just a quick update.  I don't know what I was doing wrong....m aby I had the wires mixed up or something, but I got it working again...

Now if only I can figure out why I'm not getting any video with My JRok connector.  Everything on  that is hooked up properly...

Title: Re:Coind Door Wiring, Question...
Post by: SirPeale on April 15, 2004, 07:39:27 pm

Ah, maybe you had it wired to NC instead of NO.