Build Your Own Arcade Controls Forum
Main => Buy/Sell/Trade - non-retail => Topic started by: maraxle on April 04, 2004, 08:03:17 pm
-
Hi. I recently got a T-Stik Plus with the red ball-top. Unfortunately, the dust washer that comes with the ball-tops (you know, the little ring around the base of the joystick) is smaller than the ones that come with the regular joystick, so if I push really hard in a particular direction, I can see the edge of the drilled hole. The best way I can think of to remedy this would be to stick another dust washer that's bigger under the current one. I would like two red or two black ones if anyone has some extras lying around. Thanks in advance!
-
Make your own with left over Plexi. Use a hole saw for your drill in any size you want. Run it in reverse to cut the plexi and then sand the edges. Paint them any color you want. I would use the new Fusion spray paint for plastic as it will not chip off. Or be as creative as you want.
-
How do you plan to get the dust washer past the metal ring on the stick?
-
Make your own with left over Plexi. Use a hole saw for your drill in any size you want. Run it in reverse to cut the plexi and then sand the edges. Paint them any color you want. I would use the new Fusion spray paint for plastic as it will not chip off. Or be as creative as you want.
Not a bad idea!
How do you plan to get the dust washer past the metal ring on the stick?
Since I'll just put it under the other dust washer (making a layered effect), I can make the hole slightly bigger.