Build Your Own Arcade Controls Forum

Main => Monitor/Video Forum => Topic started by: Divergcm2 on March 28, 2004, 09:39:37 pm

Title: JAMMA video connections
Post by: Divergcm2 on March 28, 2004, 09:39:37 pm

I have refurbished a JAMMA cabinet and put a 6 in 1 card in it.  The wire from the JAMMA harness to the video connector are very brittle and are starting to break.  Is there a place to just buy the new video connectors with wire and solder them into the JAMMA harness, try to get the little wires back into the clip that goes into the chassis is a pain.

Any help would be appreciated.

Mike

Title: Re:JAMMA video connections
Post by: menace on March 28, 2004, 10:10:02 pm

If I understand you right--just go to radioshack or some place similar and buy the right sized molex connectors--do some cut and splice action and you should be good to go.

Title: Re:JAMMA video connections
Post by: Ken Layton on March 28, 2004, 11:38:54 pm

I believe Bob Roberts has Jamma video cables with the connector, pins, wires, already assembled for you.