Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: Apollo on March 22, 2004, 05:47:01 pm

Title: Part of picture missing, what's up?
Post by: Apollo on March 22, 2004, 05:47:01 pm

I am running ArcadeVGA card and arcade monitor, most things run fine but some games have a couple of inches missing at the bottom of the screen eg MK1 can only see fighters from the knees up ( makes that leg sweep kinda hard, lol ). I have tried adjusting the vertical size and position of the picture but that is not the problem. Also some games have a small black square at bottom right of screen about 3cm x 3cm. Any advice or ideas on any of this?
Thankyou.

Title: Re:Part of picture missing, what's up?
Post by: GamingGreg on March 22, 2004, 07:59:45 pm

You're probably running at a resolution not supported by the card well or you're not using hardware streching when you should be.  Check the INI for that individual game.

Title: Re:Part of picture missing, what's up?
Post by: krick on March 22, 2004, 10:44:49 pm

Make sure you've run the AVRES Utility from here...
http://www.ultimarc.com/avgainst.html (http://www.ultimarc.com/avgainst.html)

...and/or...

the ArcadeVGA M.A.M.E. Resolution Tool from here...
http://mamewah.mameworld.net/downloads.html (http://mamewah.mameworld.net/downloads.html)

Title: Re:Part of picture missing, what's up?
Post by: Apollo on March 23, 2004, 03:58:55 pm

Thanks krick you are a legend. The AVRES tool fixed all my games perfectly. Yeeha just the paint to go!!! Then pics of the finished machine!!!
Thankyou, thankyou, thankyou.