Build Your Own Arcade Controls Forum

Main => Buy/Sell/Trade - non-retail => Topic started by: General Zod on March 14, 2004, 08:54:22 pm

Title: WTB : Midway Control Panel Holders
Post by: General Zod on March 14, 2004, 08:54:22 pm

I'm hoping that's the right title for these. Does anyone have an extra set they wouldn't mind parting with? I sure could use some.

PM me with pricing details or if you have any request perhaps for possible trade.

Thanks in advance.

Mike

Title: Re:WTB : Midway Control Panel Holders
Post by: Stingray on March 15, 2004, 10:15:54 am

I'll be going to the shop one day this week to build a couple of control panels. If you can give me measurements or a drawing I can make a couple of those for you while I'm there if nobody has any for sale.

-S

Title: Re:WTB : Midway Control Panel Holders
Post by: Stingray on March 15, 2004, 10:33:23 am

Fairly sloppy drawing, but if you can give me the measurements for A, B, C, D, & E I should be able to make you these with no problem. Also I'm assuming the bend is 90 degrees.

(http://pages.prodigy.net/stingrayg4/misc/arcade/midwaycp.jpg)

-S